Cooling Tower Spray Nozzle

Spiral Target Cross Flow Cooling Tower Spray Nozzle is made by PP material, and assembled by several parts. It is widely used for the counterflow cooling tower.
Spiral Target Cross Flow Cooling Tower Spray Nozzle help ensure a uniformly delivery of water over the cooling tower fill. Uniform water distribution at the top of the cooling tower fill is essential to achieve proper wetting of the entire cooling tower infill surface.

Spiral Target Cross Flow Cooling Tower Spray Nozzle is made by PP material, and assembled by several parts. It is widely used for the counterflow cooling tower.
Spiral Target Cross Flow Cooling Tower Spray Nozzle help ensure a uniformly delivery of water over the cooling tower fill. Uniform water distribution at the top of the cooling tower fill is essential to achieve proper wetting of the entire cooling tower infill surface.

The counterflow sprayer is an injection molded ABS spiral target nozzle, assembled by two parts-the main body and orifice cap. It is used in the crossflow cooling tower.

The uniform water distribution is the main factor for maintaining cooling tower efficiency. Latino's spiral target spray nozzles ensure hot water distribute uniformly to the fill blocks. This nozzle are high-temperature resistant and non-clogging designed.

Easy for installing、removing and replacing.

This plastic spray nozzle for cooling tower is made from ABS material. It has no internal parts as other nozzles. The below attached diffusion ring will not retain fibrous debris.

The unique "Full cone" distribution pattern guarantee the uniform water distribution into the cooling tower fill blocks. It could provisde the uniform water distribution even near spray boundaries with minimal spray overlap.

The diameter of water outlet is about 44mm, the outlet water pressure is very low water pressure and non-clogging.

This Spray Nozzle For Cross Flow Water Cooling Tower is made from ABS material. It has no internal parts as other nozzles. The below attached diffusion ring will not retain fibrous debris.

The unique "Full cone" distribution pattern guarantee the uniform water distribution into the cooling tower fill blocks. It could provisde the uniform water distribution even near spray boundaries with minimal spray overlap.

The diameter of water outlet is about 44mm, the outlet water pressure is very low water pressure and non-clogging.

This plastic spray nozzle for cooling tower is made from ABS material. It has no internal parts as other nozzles. The below attached diffusion ring will not retain fibrous debris.

The unique "Full cone" distribution pattern guarantee the uniform water distribution into the cooling tower fill blocks. It could provisde the uniform water distribution even near spray boundaries with minimal spray overlap.

The diameter of water outlet is about 44mm, the outlet water pressure is very low water pressure and non-clogging.

This cooling tower ABS nozzle is made from ABS material. It is widly used in the crossflow cooling tower.

It connected with the pipes by the locking and anti-loosening device, so it could been connected with the water distribution pipe firmly and ensure the safe operation of the water distribution system in a long period.

The cooling effect is very perfect, it suit for the water cooling in power plant.

Latino's cooling tower nozzles ensure hot water distribution is uniform over the cooling tower fill blocks. These cooling tower nozzles are high-temperature resistant and non-clogging designed. Removing and replacing is relatively simple and does not need to stop the regular work for the cooling tower.

Uniform distribution of water is the main factor for maintaining the cooling tower efficiency.

This cooling tower nozzle is assebled by nozzle body、adaptor and orifice. All these three components are made from PP material. You could choose the suitable orifice depend on requirement.

Lower cost with long lifetime by PP material;
Keep the water flow uniformly;
Non-clogging;
Easy cleaning;
NPT and BSP tread are available.