cooling tower pvc fill

This counterflow cooling tower fill is used in: - TSS is less than 100 PPM with good microbiological control (less than 25PPM where microbiological control is poor); - Make-up from uncontaminated sources - Water treatment using oxidizing biocides & scale inhibitors - Low cycles of concentration - Minimal airborne dust - No potential for oil or grease contamination

MC75 is a film fill system designed for counterflow towers offering you several distinct advantages. Crossed corrugations provide the surface area and turbulence to develop efficient heat transfer. The corrugations inherently establish uniform fill sheet spacing at 0.75”. MC75 fill is thermoformed from .015” thick, UV inhibited, chemically resistant polyvinyl chloride (PVC). The flame spread rating is less than 25 per ASTM E-84 and is considered self-extinguishing.

This BAC CF1200 New Type Non-Glued Counter Flow Cooling Tower Fills is used in: - TSS is less than 100 PPM with good microbiological control (less than 25PPM where microbiological control is poor); - Make-up from uncontaminated sources - Water treatment using oxidizing biocides & scale inhibitors - Low cycles of concentration - Minimal airborne dust - No potential for oil or grease contamination

This BAC CF1200 New Type Non-Glued Conter Flow Cooling Tower Fills is used in: - TSS is less than 100 PPM with good microbiological control (less than 25PPM where microbiological control is poor); - Make-up from uncontaminated sources - Water treatment using oxidizing biocides & scale inhibitors - Low cycles of concentration - Minimal airborne dust - No potential for oil or grease contamination

Cross Cooling Tower PVC Filling Material plays a crucial role in improving the lifespan of the cross flow cooling tower. It also could increases the water flow process remarkably for better performance and efficiency as well. This cross flow cooling tower PVC filling material is glued together by A type and B type sheets to be a block which is stalled in tower. This PVC fill use the modified PVC sheet and is manufactured with a unique modified formula to enable strong resistance and guarantee its durability. It involves special processing whereby the inner side edge is integrated with a liquid baffle plate which controls the drift loss of water.

This MX75 cooling tower fill virtually eliminates the nuisance caused by drift spotting on adjacent buildings and property. For additional savings, the drift eliminators discharge air directly toward the fan. Discharge air, traveling in the right direction when it leaves the eliminators, translates to lower fan horsepower.

The Cooling Tower PVC Filler is probably the most thermally efficient fill worldwide, has proven its efficiency for more than 30 years. The sharp horizontal corrugations of cooling tower PVC filler allow even water redistribution on the sheet and water rotation for good contact with air. The offset flute design allows vertical rotation of air with limited pressure drop. This type of cooling tower fill well adapted to any induced draft or natural draft cooling tower using normal industrial water quality.

Crossflow PVC film for cooling tower infill is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over large vertical surfaces, promoting maximum exposure to thevair flow. This type of fill provides much more water surface exposure per cubic foot than splash type fill.

This type of Fill is widely used in counterflow of cooling tower in power plant, petrochemical, HVAC and other process cooling towers. The Fill have vertically offset flutes arranged in a straggered pattern with adjacent sheets providing a continuous and horizontal redistribution of air and water. The flut height for each corrugation shall be 20mm.