cooling tower parts

The pvc sheet is the material of cooling tower fill, which is made by the raw mateial is PVC resion. The max. width is 1700mm, and the sheet thickness can from 0.25mm to 0.40mm.

Durable crossflow cooling tower PP infill replacement is made by PP material. It is much durable than the cooling tower PVC fill. Cooling tower PP fill is used in the counterflow cooling tower, this cooling tower infill also could been made by PVC material.

The cooling tower fill type is widely used in round cooling tower, and the material can be PVC or PP based on the usage conditions. The fill pitch is 15mm, easy to assambly at site.

Low aspect ratio increases capacity and reduces pressure drop. The preferred vertical orientation of the packing axes allows free gas flow through the packed bed. Lower pressure drop than Pall rings and saddles.

The Cooling Tower Fill Media Products is probably the fill offering the hightest resistance to scaling and fouling worldwide； Using LATINO's well proven technology of the non-contact sheets, this is a vertical core fill design with wide openings. The sheets are smooth and include a large number of square holes. The holes induce beneficial turbulence for the heat transfer, whilst no fouling or scaling occurs on the support. The laths (resulting from perforation) make this packing acting partly like a grid type. Therefore, it is an excellent alternative to « mesh » or « 3D grids ». It can be produced in PP.